Wiring the AP Link Lever

Wire together...

 Now that we have eliminated the gap between the AP Link Lever and the AP Set Screw, we are now ready to wire them together. As noted earlier, Jimbo45 was successfully able to utilize an O-Ring (5/16" I.D. x 7/16" O.D.) to secure the AP Link Lever to the AP Set Screw. This is also an option. By utilizing a rubber o-ring, you could possibly eliminate some of the added stress that might be induced to the AP Diaphragm. We have not encountered any Diaphragm failures due to wiring, but the choice is up to you. Start of by grabbing some thin safety wire. Cut a small piece off, and make a loop, go ahead and start a few twists. This will make it easier to attach and fasten.

Place wire...

 After you have your safety wire loop made, place it over and behind the AP Set Screw and around the AP Link Lever. Gently tighten until all of the slack is out and you have firmly fastened the AP Link Lever to the AP Set Screw.